Segway I Series Spécifications télécharger pdf (Page 40)

service

Reseat the Battery Packs

Tool Required: 3 mm hex wrench.

1. Make sure the Segway HT is powered off and not

plugged in. It is unsafe to perform this procedure while

the Segway HT is powered on or charging.

2. Reseat Battery Packs on chassis with curved edge

facing outside of chassis.

3. Thread in the fasteners and tighten with the 3 mm

hex wrench (4 per Battery Pack). To avoid risk of

damage, do not use a power tool to thread in or

tighten fasteners.

Tightening Torque: 1.0 N-m (8.9 in-lbf)

Remove Tire/Wheel Assembly

Tools Required: 16 mm deep socket wrench with

8" (20 cm) or longer wrench handle, rubber mallet, for

the Segway XT you will also need a minimum

3” (75 mm) socket extension/extension bar.

1. Make sure the Segway HT is powered off and not

plugged in. It is unsafe to perform this procedure while

the Segway HT is powered on or charging.

2. Tip the Segway HT onto its side so that the outside

of one wheel lays flat against a clean, smooth

surface. (The p Series wheel is dome-shaped and

will not lay flat. Make sure to protect the Wheel

from damage by placing it on a thick, soft surface.)

3. Remove the Wheel Nut with a 16 mm deep socket

wrench. Hold the wheel from rotating and turn the

wrench counterclockwise. (This may require

considerable force.)

4. Strike the outside edge of the tire with a rubber

mallet to unseat the wheel hub taper. (This may

require multiple attempts as the wheel hub is

seated tightly into the Gearbox taper.)

5. Lift off the wheel.

6. Clean any debris from outside of drive shaft and

inside of wheel hub.

Reseat Tire/Wheel Assembly

Tools Required: 16 mm deep socket wrench with

8" (20 cm) or longer wrench handle, for the Segway XT

you will also need a minimum 3” (75 mm) socket

extension/extension bar.

1. Make sure the Segway HT is powered off and not

plugged in. It is unsafe to perform this procedure while

the Segway HT is powered on or charging.

2. Place the wheel hub opening over the Gearbox drive

shaft; rotate the wheel while pressing down until

the wheel seats.

3. Thread on the wheel nut and tighten with the socket

wrench.

Tightening Torque: 50.0 N-m (36.9 ft-lbf)

WARNING!

The cells within the Battery Packs contain toxic

substances. Do not attempt to open Battery

Packs. Do not use the Battery Pack if its casing

is broken or if it emits an unusual odor or

excessive heat or leaks any substance. Do not

handle a damaged or leaking Battery Pack

unless you are wearing disposable rubber

gloves, eye protection, and are in a well-

ventilated area. Dispose of rubber gloves and

damaged Battery Pack properly in accordance

with regulations governing disposal of toxic

materials.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Segway I Series Spécifications Page 40

Commentaires sur ces manuels

Produits connexes et manuels pour Scooters Segway I Series