21
Adapter should snap into place when screwed on.
To remove the InfoKey Controller Dock Adapter, unscrew the adapter from
the underside of the InfoKey Controller.
Dock the InfoKey Controller
Tool Required: None
To dock the InfoKey Controller:
1. Make sure the Segway PT is unplugged and powered off.
2. Ensure the InfoKey Controller Dock Adapter is installed (see "Install
the InfoKey Controller Dock," p. 20).
3. Slide the InfoKey Controller up into the InfoKey Controller Dock.
Adjust the Handlebar Height
Tool Required: None
To adjust the Handlebar height:
1. Loosen the Height Adjustment knob.
2. Adjust the height of the upper LeanSteer Frame by pulling up on the
Handlebar until the Handlebar is just above your elbow or higher
while you are standing on the floor and the Powerbase is level. You
can adjust as necessary for comfort.
3. Tighten the Height Adjustment knob.
NOTE:
The handlebar should be adjusted for each rider. Adjusting the Handlebar to
the correct height is important for both safety and comfort.
Figure 8: Dock the InfoKey Controller
Figure 9: Adjust the Handlebar Height
2
3
Commentaires sur ces manuels