Segway x2 SE Turf Manuel d'utilisateur Page 24

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 148
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 23
22
Assembling Your Segway PT (cont.)
Install the Batteries
WARNING
Refer to "Segway PT Batteries" (p. 85) for battery-related safety precautions
and handling instructions.
NOTICE
To avoid risk of damage, do not use power tools. Use only Segway approved
fasteners.
Tool Required: Torque wrench with 3 mm bit
To install the Batteries:
1. Make sure the Segway PT is unplugged and powered off.
2. Install one of the Batteries to the Powerbase, with the curved edge
of the Battery to the outside of the Powerbase.
3. Ensure the Battery is aligned straight against the Powerbase edge
trim, and there are no uneven gaps.
4. Install the two center fasteners first; do not tighten.
5. Install the two outer fasteners; do not tighten.
6. Torque the center fasteners first, then the outer fasteners to
1.6N-m(14in-lbf).
7. Verify the Battery is aligned straight against the Powerbase edge
trim, and there are no uneven gaps.
8. Repeat Steps 1-7 for the second Battery.
Figure 10: Torque the two center fasteners first.
Vue de la page 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 147 148

Commentaires sur ces manuels

Pas de commentaire